RealFlow Official Forum

While trying to learn this software, I set up a simple scene with a box, a circular emitter1, and a circular emitter2. Emitter2 was a direct copy of emitter1. I then set up fluid1 linked it to emitter1; and fluid2 linked it to emitter2. When I ran the scene, emitter1 appeared to emit particles noticeably faster and with greater pressure than emitter2. I double checked --- emitter1 and emitter2 setups are identical, as are fluid1 and fluid2 setups.

Any ideas?

Hi kurasdan,

Do you have the scene to try here?. Also, have you checked out if the velocity is the same for both emitters or some daemon is affecting only one fluid. I guess so.

Let me know.

luisM.