RealFlow Official Forum

Hi, i have this problem with small particles during meshing that flicker really bad. I think its the sheeter deformer. If i use K-isolated, it doesnt mesh it the same ofc, and it doesnt also completely eliminate the problem. If i up substeps, i get a completely different sim.
So any ideas how to keep a sim like this and kill the small ones only? see link below, ty

https://www.dropbox.com/s/negg0hsih54yo ... c.mp4?dl=0

Also i wanted to ask, if its a mesh problem. Low to medium can solve this for example? Cause i usually use low-medium or low with some smoothing and looks ok and i was wondering if that might be a problem and actually for production i need to go a lot higher even if i can make it look good with lower polys.

Sorry if its completely basic stuff i dont use RF often. thanks