RealFlow Official Forum

Hi everyone,
2nd question today...
I have the emitter with an allign to spline tag, and am attempting to write a word in melted chocolate on a table.
Im having trouble with the consistancy of the liquid, and with the flow...
Has anyone tried this? Any tips for me?
Thx again,
Simon

Hi

it is difficult when you try to directly use the splines that make the letters, because the point density is different in different parts and the speed of the emitter varies too much or travels in the wrong direction. You might need to re-trace the letters with an un-interrupted spline that has an even distribution of anchor points, I think.
Alternatively you could use the letters as emitters of particles, but then you loose the writing animation.