Page 1 of 1
extra data out from H2 in alembic mesh sequence
Posted: Tue Jun 04, 2013 6:38 am
by o.delellis@gmail.com
hi,
anyone has managed to get a *.abc Hybrido2 mesh in to maya and access the extra channels?
velocity
vorticity
curvature
splashity (?)
Re: extra data out from H2 in alembic mesh sequence
Posted: Wed Jun 05, 2013 2:23 am
by o.delellis@gmail.com
ok,
so i used the batch script from the beta forum as stitcher.exe doesnt work for windows in command line...
it works sort of, it makes a suspiciously small file (4.85kb) from a 30 frame abc sequence (all up 17MB)...when loaded in to maya, it loads, but i get zero poly's
any ideas what is wrong?
the batch script seems to run fine, no errors..
Re: extra data out from H2 in alembic mesh sequence
Posted: Wed Jun 05, 2013 7:17 am
by o.delellis@gmail.com
oook,
i dont know what was wrong with that mesh.
i did another one and it did work...wiiiiiiiiiii!!!!
i was getting an error that there was no 'output' file, there was, the error is i was missing a "/" on the INPUT...go figure.
..now lets see if it works with a production strength mesh
Re: extra data out from H2 in alembic mesh sequence
Posted: Wed Jun 05, 2013 10:51 am
by gus
o.delellis@gmail.com wrote:oook,
i dont know what was wrong with that mesh.
i did another one and it did work...wiiiiiiiiiii!!!!
i was getting an error that there was no 'output' file, there was, the error is i was missing a "/" on the INPUT...go figure.
..now lets see if it works with a production strength mesh
Just when I was about to reply to your email
Let us know how it goes.
g-)