RealFlow Official Forum

Hi Guys, I would like to ask some help and advice with the predicament I am having right now.
specially with regards to Hybrido 2 ,initial state setup and Job manager.
I am working on a Hybrido scene where I have to set an initial state. so after setting this up. I tried to send a simulation job thru the network using realflow's job manager. And this is my first problem, when I click the bottom right button where it says "send to job manager" I get an error message "Connection to job Manager error: Host not found".I believe I have setup job manager properly , and I believe if I hit Ctrl + F4 and the UI of job manager pops out the realflow GUI, I can safely assume the job manager is working properly?

So my work around for now is, open Job Manager from an outside web explorer such as google's Chrome (using port 8080) and submit the jobs in there.
so far it has been working well with my other shots. until a shot that needs to use initial state came in. After setting up everything and tried my usual work around, what I am noticing right now, is that its not picking up to where the initial state should be, instead it started on zero state.

Thanks once again, any advice and help is greatly appreciated.

cheers.

~alvin

Hello Alvin,

Check Preferences>Job manager, and make sure you have set the ip where the job manager is running and you choose properly the plugin. See the attached image.

luisM.

Thank you very much Luis, its now working, it was the ":8080" on the ip adress that was giving me
those errors, as soon as that number removed everything just fell into places.

Thank you once again