RealFlow Official Forum

Hello,

I'm working on a scene that contains jets of water that shoots up like a Geyser... I want to key frame when they erupt and when they stop. I also want to control the flow.

I'm not sure how to do this in Reaflow 2014... Has anyone had experience doing this and if so, how could I keyframe when an emitter starts and stops and also control the pressure?

Regards,
Dan

I've something for you: a geyser tutorial from the RF4 manual. Outdated in terms of GUI, but the principles behind this didn't change, so I'm pretty sure it can be used. Daemons will most probably react differently, but this is something that can be adjusted.

Do you perhaps have an email address for me via PM? The PDF is too big to be attached here.

Cheers,
Thomas