RealFlow Official Forum

Hi,
I can't find the answer of this VERY basic question about Hybrido searching on the net. So I ask here again, sorry.
I'd like to stop the Hybrido emission (stream) at some frame.
I did found a harsh solution : stop the simulation , disconnect the emission object from the emitter (Emitter/Object: None), restart simulation at the right frame.
I guess there is there a smarter way ?
Thanks again

Hey,

just place a couple of keys. First one in the frame 0 with stream to Yes, and another one when you want to stop the simulation. Next, open the Curve editor and set the curve to "stepped".

luisM.

Thanks !
simple and effective