Simulation wont work with HY_Splash_Foam emitter.
Posted: Sat Sep 16, 2017 7:21 pm
The sim works fine with a normal emitter, but once I add or activate a splash foam emitter it doesn't emit any particles at all?
Hard to tell from a distance what's going on, so it might be obvious, but did you check if the simulations nodes connected correctly ("Relationship Editor"), do you use the same splash settings as with the single splash emitter, and is the splash-foam emitter's domain placed and positioned correctly?
It'd be very helpful you could send us your project or create a basic setup where the error is visible too.