I completely understand it is a beginner tutorial, but this course barely seemed to scrape the surface of the software compared to the very nice 'Introduction to Realflow 5' and 'intro to RF2012' courses that Digital tutors have done in the past.
I was most looking forward to learning a bit more about updated meshing options in rf2013 & more about Hybrido 2....but the digital tutors 'intro to rf2013' course has just 3 of the 26 videos focused on those 2 topics and they are incredibly basic and lacking! You can learn much more from the 'introducing RealFlow 2013' teaser trailers that Next Limit put out a few months ago!!
