To this are 6 emitters are linked to a part that cycles aroung it's own axis and around the middle of the dishwasher.
While simulating this I noticed that at frame 45 there is 1 frame of interruption of the flow.
It's almost as if an invisible collision happens with all 6 emitters at frame 45.
![Image](http://www.m.rckmn.nl/_/expl.jpg)
While trying to analyze the problem I couldn't figure it out.
Changing the sub-steps / collision objects / liquid resolution didn't matter.
So i tried to adjust the animation curve of the SD file and imported it again.
with the adjusted animation the same thing now happens at frame 37.
It turns out that when the original driving dummy is rotated at ~61/62 degrees the small 1 frame explosion occurs.
does this sound familiar to anyone ?
i've attached the realflow file where it will explode at frame 45.
only 2 of the six emitters are on at very low resolution.